# TruFlat laser settings for Thunder Laser Bolt

Verified laser settings to cut and engrave TruFlat (plywood - mdf) on the Thunder Laser Bolt, a 30W RF laser. Cut: 10 mm/s, 75% power, 0 passes. Engrave: 300 mm/s, 30% power, 1 pass.

- Source page: https://thelaserworkshop.com/community/material/truflat-settings-thunder-laser-bolt-d52f173c-bc29-40f6-83c1-619b1f56dd98
- Shared by: MakerFlo
- Status: Verified by The Laser Workshop
- Material category: Plywood - MDF
- Machine: Thunder Laser Bolt (30W RF laser)
- Last updated: 2026-02-15

## Cut settings

| Setting | Value |
| --- | --- |
| Speed | 10 mm/s |
| Power | 75% |
| Passes | 0 |

## Engrave settings

| Setting | Value |
| --- | --- |
| Speed | 300 mm/s |
| Power max | 30% |
| Density | 508 LPI |
| Passes | 1 |

## Before you run this job

Settings vary between individual machines, even of the same model. Run a test card on scrap material first, never leave the laser unattended, and never cut PVC or vinyl.

## Related settings

- [All Thunder Laser settings](https://thelaserworkshop.com/brand/thunder-laser)
- [MakerFlo materials and settings](https://thelaserworkshop.com/supplier/makerflo)