Back to Community Laser Settings
Buy This Product
Wood
1/8-inch White PlyCore
Shared about 1 month agobycreatedworkshop
Community-shared laser settings to cut 1/8-inch White PlyCore (wood) on the xTool P3, an 80W CO2 laser. Cut: 20 mm/s, 85% power, 1 pass.
xTool P3
80W CO2 Laser Source
Cut
Speed 20mm/s
Power 85%
Passes 1
Did this work for you?
No feedback yet
Settings vary between individual machines, even of the same model. Run a test card on scrap material first, and never leave your laser unattended.
More xTool P3 settings
- Black Walnut
- Round Glass Ornaments
- Small Cutting Board with Handle - Acacia
- Leatherette Notebooks - Green to Black
- Leatherette Passport Holders Red to White
- Denim Beige/Black Leatherette