Back to Community Laser Settings
Wood
Black Walnut
Shared 7 months agobycreatedworkshop
Community-shared laser settings to engrave Black Walnut (wood) on the xTool P3, an 80W CO2 laser. Engrave: 600 mm/s, 50% power, 1 pass.
xTool P3
80W CO2 Laser Source
Engrave
Speed 600mm/s
Power Max 50%
Density160 LPCM
Passes 1
Did this work for you?
No feedback yet
Szuch Design
View Supplier PageSettings vary between individual machines, even of the same model. Run a test card on scrap material first, and never leave your laser unattended.
More xTool P3 settings
- 1/8-inch White PlyCore
- Round Glass Ornaments
- Small Cutting Board with Handle - Acacia
- Leatherette Notebooks - Green to Black
- Leatherette Passport Holders Red to White
- Denim Beige/Black Leatherette