Skip to main content
The Laser Workshop
Back to Community Laser Settings
Bamboo
Wood

Bamboo

Shared 7 months agobycreatedworkshop

Community-shared laser settings to engrave Bamboo (wood) on the xTool F1 Ultra, a 20W Diode laser. Engrave: 350 mm/s, 100% power, 1 pass.

xTool

xTool F1 Ultra

20W Diode Laser Source

Engrave
Speed 350mm/s
Power Max 100%
Density160 LPCM
Passes 1

Did this work for you?

No feedback yet

Szuch Design

Szuch Design

View Supplier Page

Settings vary between individual machines, even of the same model. Run a test card on scrap material first, and never leave your laser unattended.

More xTool F1 Ultra settings

All xTool F1 Ultra laser settingsxTool machines and settings

Built by The Laser Workshop.

Disclosure: We use affiliate links throughout the site. If you make a purchase using a link on this site, we may receive a small commission at no cost to you.