Back to Community Laser Settings
VerifiedPlywood - MDF
TruFlat
Shared 8 months agobyMakerFlo
Verified laser settings to cut and engrave TruFlat (plywood - mdf) on the Thunder Laser Bolt, a 30W RF laser. Cut: 10 mm/s, 75% power, 0 passes. Engrave: 300 mm/s, 30% power, 1 pass.
Thunder Laser Bolt
30W RF Laser Source
Cut
Speed 10mm/s
Power 75%
Passes 0
Engrave
Speed 300mm/s
Power Max 30%
Density508 LPI
Passes 1
Did this work for you?
No feedback yet
MakerFlo
View Supplier PageSettings vary between individual machines, even of the same model. Run a test card on scrap material first, and never leave your laser unattended.