Thunder Laser Bolt Laser Settings
1 setting tested on the Thunder Laser Bolt, a 30W RF laser, covering plywood. 1 is verified by The Laser Workshop or the manufacturer. Select a material for its full settings, notes, and photos.
Thunder Laser Bolt engraving settings
| Material | Speed | Power | Density | Passes |
|---|---|---|---|---|
| TruFlatPlywood - MDF | 300 mm/s | 30% | 508 LPI | 1 |
Thunder Laser Bolt cutting settings
| Material | Speed | Power | Passes |
|---|---|---|---|
| TruFlatPlywood - MDF | 10 mm/s | 75% | 0 |
Before you run these settings
Settings vary between individual machines, even of the same model: lens, focus, alignment, air assist, and the exact material all change the result. Run a small test grid on scrap from the same sheet first, never leave the laser unattended, and never cut PVC or vinyl.
Settings for other lasers
- xTool F1 (14)
- xTool P3 (9)
- xTool S1 (6)
- Aeon Laser MIRA 9 (3)
- xTool F1 Ultra (3)
- Thunder Laser Nova 24 (1)
Have a setting that works on your Thunder Laser Bolt? Create a free account to save it and share it with the community.