Back to Community Laser Settings
Buy This Product
Wood
Stanley Wooden Handled Hammer
Shared 8 months agobycreatedworkshop
Community-shared laser settings to engrave Stanley Wooden Handled Hammer (wood) on the xTool P3, an 80W CO2 laser. Engrave: 400 mm/s, 80% power, 1 pass.
xTool P3
80W CO2 Laser Source
Engrave
Speed 400mm/s
Power Max 80%
Density200 LPCM
Passes 1
Did this work for you?
No feedback yet
Settings vary between individual machines, even of the same model. Run a test card on scrap material first, and never leave your laser unattended.
More xTool P3 settings
- 1/8-inch White PlyCore
- Black Walnut
- Round Glass Ornaments
- Small Cutting Board with Handle - Acacia
- Leatherette Notebooks - Green to Black
- Leatherette Passport Holders Red to White