Aeon Laser MIRA 9 Laser Settings
3 settings tested on the Aeon Laser MIRA 9, a CO2 laser, covering acrylic, mdf and plywood. Select a material for its full settings, notes, and photos.
Aeon Laser MIRA 9 engraving settings
| Material | Speed | Power | Density | Passes |
|---|---|---|---|---|
| Acrylic SheetAcrylic | 200 mm/s | 40% | 1016 LPI | 1 |
| TruFlatPlywood | 250 mm/s | 45% | 1016 LPI | 1 |
Aeon Laser MIRA 9 cutting settings
| Material | Speed | Power | Passes |
|---|---|---|---|
| Acrylic SheetAcrylic | 15 mm/s | 85% | 2 |
| TruFlatMDF | 15 mm/s | 75% | 2 |
| TruFlatPlywood | 15 mm/s | 75% | 2 |
Aeon Laser MIRA 9 scoring settings
| Material | Speed | Power | Passes |
|---|---|---|---|
| Acrylic SheetAcrylic | 200 mm/s | 40% | 1 |
| TruFlatPlywood | 300 mm/s | 0% | 1 |
Before you run these settings
Settings vary between individual machines, even of the same model: lens, focus, alignment, air assist, and the exact material all change the result. Run a small test grid on scrap from the same sheet first, never leave the laser unattended, and never cut PVC or vinyl.
Settings for other lasers
Have a setting that works on your Aeon Laser MIRA 9? Create a free account to save it and share it with the community.