OMTech Polar Laser Settings
1 setting tested on the OMTech Polar, a CO2 laser, covering acrylic. Select a material for its full settings, notes, and photos.
OMTech Polar engraving settings
| Material | Speed | Power | Density | Passes |
|---|---|---|---|---|
| Matte/Gloss Acrylic (Solid Colors)Acrylic | 200 mm/s | 25% | 355 LPI | 1 |
OMTech Polar cutting settings
| Material | Speed | Power | Passes |
|---|---|---|---|
| Matte/Gloss Acrylic (Solid Colors)Acrylic | 10 mm/s | 55% | 1 |
OMTech Polar scoring settings
| Material | Speed | Power | Passes |
|---|---|---|---|
| Matte/Gloss Acrylic (Solid Colors)Acrylic | 220 mm/s | 20% | 1 |
Before you run these settings
Settings vary between individual machines, even of the same model: lens, focus, alignment, air assist, and the exact material all change the result. Run a small test grid on scrap from the same sheet first, never leave the laser unattended, and never cut PVC or vinyl.
Settings for other lasers
- xTool F1 (14)
- xTool P3 (9)
- xTool S1 (6)
- Aeon Laser MIRA 9 (3)
- xTool F1 Ultra (3)
- OMTech AF Series (80W) (1)
Have a setting that works on your OMTech Polar? Create a free account to save it and share it with the community.