About this project
- Category
- Jewelry
- Difficulty
- Beginner
- Time
- 5 min
Questions about this project? The guide covers settings, materials and test cuts.
You don't need a MOPA laser to get black on stainless steel. I ran this on the OMTech G3, a 30W Q-switched fiber laser, and it took grid after grid to dial in. Use my settings as a starting point and run your own test grid, since every machine and every batch of blanks is a little different.
Defocus up 1/4 inch. I set a 1/4" block on top of the necklace and set the laser height from that. Defocusing makes the spot a little bigger and softer, so the laser anneals the metal instead of ablating it.
Turn overscan off. LightBurn had it on by default for this laser, and it threw my results off. Overscan matters on gantry lasers like CO2 and diode, not on a galvo fiber.
Test with the actual design. My settings for solid squares weren't the same as my settings for names. A filled square puts much more heat into the metal than thin script text does, so test with text like you'll really engrave.
Keep the necklace flat. The jump rings tilt the blank slightly, which makes the engraving a little different from top to bottom. Set the blank on a flat block so the whole design stays in focus.
To run a test grid in LightBurn: Laser Tools > Material Test. You can only vary two settings at a time, so start with small grids and work outward.
Settings that worked for other makers, by machine and material. Always run a test first.
No laser profiles yet
Did these settings work on your machine? Add them so the next maker has a starting point.
Be the first to make this
Made your own version? Tap Made it at the top of the page and share a photo and the settings you used.
Comments · 0
Be kind and helpful. Comments are shown right away and can be reported.
No comments yet. Have a question or a tip? Start the conversation.